Band saw cutting machine
Automatic cutting part of finished plate
Double crawler rear output roller table
The double-track rear output roller is a non-powered retractable free-roller output roller, which is connected to the automatic cutting machine and has a length of 2000mm and a width of 1220mm.
Band saw cutting
The band saw is a continuous production when cutting, and does not need to stop for operation. It includes the following parts:
l A high-speed three-phase motor drives the band saw wheel to drive the band saw for cutting.
l When the band saw is cutting, the cylinder on the knife holder presses the plate tightly
l Tension the band saw through a mechanical device
l The band saw is driven by a motor to reciprocate
l The electrical control console includes PLC and electrical control
l Different production speeds are controlled by synchronous motor frequency conversion
l Calculate the length through PLC and program
l The band saw is surrounded by guardrails and shields to reduce noise. These guardrails and shields are made of produced plates.
The working status of the band saw is as follows:
When cutting the plate, the rubber-attached pressing plate will press the plate, and the band saw will cut two layers of steel plates and the core material in the middle of the steel plates at one time;
l When the band saw is cutting the male and female edges of the plate, it will automatically slow down;
After one cut is completed, the band saw will rotate 180° to prepare for the next cut. Because the band saw blade can rotate, it can also perform bidirectional cutting. After cutting, release the cylinder that clamps the plate, and the band saw will reset to prepare for the next cut;
Before the next cutting, the knife holder will be reset to its original position;
l Band saw cutting can be set to manual cutting or automatic cutting;
l The maximum plate width of the band saw is 1250mm and the maximum plate thickness is 250mm
l The moving distance of the cutting machine along the production direction is 2500mm;
l The lateral movement distance of the band saw cutting is 1700mm, and its longitudinal and lateral movement are along the guide rail direction;
The dimensional tolerances for plate cutting are as follows:
l Cutting length less than 6m: +/-2mm
l Cutting length greater than 6m: +/-(3-5)mm
Cutting length of band saw:
The maximum cutting length is limited only by the rear conveyor frame
The minimum cutting length is 3.5m when the main machine speed is 5m/min
The conveyor frame after band saw cutting is a non-powered conveyor roller. The length of the entire conveyor frame is about 15m and the width is 1250mm.
The conveyor after band saw cutting is powered by rubber rollers, chain driven and equipped with guide wheels. The length of the entire conveyor is about 15m and the width is 1250mm.
CONTACT US
Tel:0086-21-57604761, 57604762, 57602104
Fax:0086-21-57604761
Mobile phone:13801798375
E-mail:shanghaiyongming@126.com
Add: No. 425, Huiye Road, Chedun Town, Songjiang District, Shanghai
Thank you for contacting us
Page copyright: Shanghai Yongming Machinery Manufacturing Co., Ltd. Website:www.300.cn SEO